• Danby 644bls bad foam problem

Kegerator Forum: Danby 644bls bad foam problem

Need Kegerator Help?
Have an account?
Username

Password


  Remember me
Kegerator Community Home  »  Draft Beer Dispensing at Home » Kegerator Problems & Troubleshooting » Danby 644bls bad foam problem
Posted:  25 Dec 2011 07:25

Registered User
Currently Offline 		Posts:  1
Join Date: Dec 2011
I bought it used from a friend, and it has been sitting idle for a couple years. Some corrosion
on the coupler that cleaned up well prior to tapping. If I pull the tap for a few seconds I can get a clean pour, but I'm wasting 2 beers every 10 or so. Also I put a cup of water in the kegerator with a digital temp probe in it, and the lowest temp I've seen is 39, but it hovers at 39. Won't that cause problems as well? Planning on buying a new coupler, beer line and faucet just to make sure everything is good.